Ensure that the ignition is turned off before starting installation.
The unit is connected to the engine using the attached colour coded wires and the supplied
cable connectors.
Connect this to the coil negative (-) terminal
Connect this to the coil positive (+) terminal. If this is not easily accessible
then this wire can be connected to any positive feed that is switched by
the ignition switch.
BLACK WIRE
Connect this wire to any good electrical connection on the car bodywork.
A self-tapping screw and spring washer are supplied for this purpose if no
bolt heads are within easy reach of the wire. It is essential that a good
quality connection is made.
Keep wires clear of hot or rotating parts using the supplied cable ties.
CDi IGNITIONS - Telephone our help line for specific instructions.
Distributorless Systems - Use the tachometer output from the ECU, or one of the coil
negative connections. For dual coil vehicles ALWAYS set the number of cylinders to two.
MOUNTING THE UNIT - Remove the backing from the adhesive pad on the back of the unit
and mount it to a clean, flat, grease-free surface. Keep the unit away from hot or exposed
areas. Ensure that the unit and all wires are kept as far as possible from the HT parts
of the ignition system.
MOUNTING THE LED MODULE - The LEDs have a narrow viewing angle so ensure that the
module is facing straight towards the driver. Mount the module using the supplied adhesive